・「円の中心」を「固定」拘束
・「線分」に「垂直」拘束
・「線分の中点」と「円の中心」で「一致」拘束
次に、寸法拘束の為に「構築ジオメトリ」で「点」を作成すること。
・「点」と「線分」で「一致」拘束
・「円」と「線分」で「一致」拘束
これであとは、「長さ」と「直径」の寸法拘束を作成します。
・「円の中心」を「固定」拘束
・「線分」に「垂直」拘束
・「線分の中点」と「円の中心」で「一致」拘束
次に、寸法拘束の為に「構築ジオメトリ」で「点」を作成すること。
・「点」と「線分」で「一致」拘束
・「円」と「線分」で「一致」拘束
これであとは、「長さ」と「直径」の寸法拘束を作成します。
This entry was posted on 木曜日, 4月 2nd, 2009, 4:48 PM and is filed under Geometric Constraints. You can follow any responses to this entry through RSS 2.0. You can leave a response, or trackback from your own site.
Fusion theme by digitalnature | powered by WordPress
Entries (RSS) and Comments (RSS) ^